Parker BDNN8-0620050-1 Nylon Tubing 0.375 in Id 50 Ft 250 Psi

Product Description

The PARKER BDNN8-0620050-1 is a flexible nylon tube supplied in a 50-foot coil, designed for routing air, water, hydraulic fluid, lubricants, chemicals, and pesticides in light industrial and fluid-handling applications. The tube measures 0.375 inches inside diameter and 0.5 inches outside diameter, with a maximum working pressure of 250 psi. Its operating temperature range of -65 degrees F to 200 degrees F makes it suitable for both indoor and outdoor service environments. The natural-colored nylon construction resists many common chemicals and provides the flexibility needed for routed plumbing in tight spaces.

This nylon tubing is well suited for pneumatic lines, fluid transfer, and instrumentation runs in commercial, industrial, and agricultural settings. Typical applications include compressed air distribution, chemical feed lines, lubrication systems, and pesticide delivery in spray equipment. The 50-foot coil length supports longer continuous runs without inline fittings, reducing potential leak points. Plumbers, pipefitters, HVAC technicians, and industrial maintenance professionals commonly work with this type of flexible tubing for both new installations and repair work.

Key Features

• Flexible nylon construction with a minimum bend radius of 1.25 inches
• 0.375 inch inside diameter and 0.5 inch outside diameter for consistent flow and fitment
• Rated to 250 psi maximum working pressure
• Wide temperature range: -65 degrees F to 200 degrees F
• Compatible with air, water, hydraulic fluid, lubricants, chemicals, and pesticides
• Supplied in a 50-foot coil for continuous runs with minimal joints

Compatibility

Designed as a general-purpose flexible nylon tube for use with air, chemicals, hydraulic fluid, lubricants, pesticides, and water in pneumatic and fluid-transfer systems.

Installation Notes

Cut tubing to length using a clean, square tube cutter or sharp utility knife to ensure a proper seal at push-to-connect or compression fittings. Power down or depressurize the system fully before disconnecting existing lines or making new connections. Observe the minimum bend radius of 1.25 inches to prevent kinking and flow restriction. A licensed technician or qualified tradesperson should verify that working pressure and temperature ratings are appropriate for the specific application before installation.