Parker 801-16-RED-RL Multipurpose Air Hose 1 in 150 Ft

Product Description

The PARKER 801-16-RED-RL is a multipurpose air hose designed for demanding pneumatic and compressed-air applications across industrial, commercial, and trade environments. Built from synthetic rubber, the hose handles a working pressure of 200 psi and operates across a wide temperature range of -40 to 257 degrees F. With a 1-inch inside diameter and 150-foot length, it delivers high-volume airflow over extended runs. The red outer jacket aids quick visual identification on busy job sites. HVAC technicians, plumbers, pipefitters, and general contractors rely on this type of hose for air tool operation, pneumatic controls, and blow-off service.

This hose suits a broad range of applications including construction sites, mechanical rooms, and service shops where long runs are required. The 1-inch bore supports high-demand air tools and multiple drops off a single compressor feed. The synthetic rubber construction resists abrasion, flexing, and moderate oil exposure, making it well suited for floor-level use in shop and field environments. It ships as a single 150-foot reel with no end fittings attached, allowing the installer to terminate with the appropriate couplings for the application.

Key Features

• 1-inch inside diameter supports high-volume airflow for demanding pneumatic tools and equipment
• 150-foot length allows extended reach without inline joiners
• 200 psi working pressure rated for standard compressed-air systems
• Wide service temperature range of -40 to 257 degrees F suits both cold-climate and high-heat environments
• Synthetic rubber construction resists abrasion and repeated flexing
• Red outer jacket provides easy visual identification on job sites

Compatibility

Designed as a general-purpose replacement or new-installation air hose for compressed-air systems requiring a 1-inch ID hose with 200 psi working pressure and synthetic rubber construction. No end fittings are included; field termination is required.

Installation Notes

Installation should be performed by a qualified tradesperson familiar with compressed-air system plumbing and applicable codes. Depressurize and lock out the compressor system before making any hose connections. Select end fittings rated at or above the 200 psi working pressure of this hose. Avoid sharp bends at the termination points, as kinking near fittings is a common cause of premature hose failure.