Parker 71216SN1GL00 Solenoid Valve 1/8 in Npt

Product Description

The PARKER 71216SN1GL00 is a direct-acting solenoid valve designed for precise fluid control in demanding industrial and commercial applications. It features a 1/8 inch NPT port, a stainless steel body, and a nylon seal, making it suitable for use in corrosive or moisture-prone environments. The valve is normally closed in its unactuated state and supports a wide range of operating voltages including 12V DC, 24V DC, 24/60V AC, 120V DC, 120/60-110/50V AC, 240/60-220/50V AC. Maximum working pressure is rated at 1250 psi. Note that this valve requires a separately purchased integrated coil for complete operation.

This valve is well-suited for HVAC, refrigeration, pneumatic, and fluid control systems where a compact, multi-voltage normally closed solenoid valve is required. Its stainless steel construction supports installation in environments where corrosion resistance is critical. The minimum operating pressure differential is 0 psi, allowing the valve to operate even at low or no differential pressure conditions. Licensed HVAC technicians, plumbers, and industrial service professionals are the typical installers of this component.

Key Features

• Direct-acting design operates at 0 psi minimum pressure differential
• Stainless steel body for corrosion resistance in demanding environments
• Nylon seal compatible with a range of media
• Normally closed valve state for fail-safe fluid shutoff
• Multi-voltage compatibility: 12V DC, 24V DC, 24/60V AC, 120V DC, 120/60-110/50V AC, 240/60-220/50V AC
• CSA Certified, UL Listed, and NEMA 4X rated for wet and washdown locations
• Requires a separately sourced integrated coil for complete valve assembly

Compatibility

Designed as a direct-acting normally closed solenoid valve for use in fluid and pneumatic control systems requiring a 1/8 inch NPT connection and multi-voltage coil compatibility. Coil must be purchased separately and must be compatible with an integrated coil design for this valve body.

Installation Notes

Installation should be performed by a qualified technician familiar with fluid or pneumatic system work and applicable codes. Always isolate and depressurize the system before removing or installing the valve. Verify that the separately sourced coil voltage matches the supply circuit before energizing. NEMA 4X rating permits use in wet locations, but all wiring connections must comply with NEC requirements for the installation environment.