Parker 60VL-8 Compression Tube Sleeve 1/2 Inch Buna-n

Product Description

The PARKER 60VL-8 is a compression tube sleeve designed to create a secure, leak-resistant connection in hydraulic and fluid transfer lines. The sleeve works by compressing around the outside diameter of the tubing as the fitting is tightened, forming a mechanical seal without the need for flaring or soldering. Constructed from Buna-N (nitrile rubber), the 60VL-8 provides reliable service across a wide temperature range from -30 degrees F to 135 degrees C and is manufactured to meet ISO 6149 and SAE J1926 standards. This part is sold and installed individually and is suited for use by licensed plumbers, hydraulic technicians, and fluid system specialists.

The 60VL-8 is intended for use in hydraulic lines, pneumatic systems, and general fluid transfer applications where a compression-style connection is specified. With a 1/2 inch tube outside diameter and NPTF thread standard, it fits into systems requiring a National Pipe Taper Fuel thread interface. Common installation scenarios include mobile hydraulic equipment, industrial machinery fluid circuits, and commercial plumbing assemblies where Buna-N material compatibility with petroleum-based fluids is required.

Key Features

• Buna-N (nitrile) construction for compatibility with petroleum-based and water-based hydraulic fluids
• Compression-style end connection eliminates the need for flaring or soldering during installation
• 1/2 inch tube outside diameter fits standard half-inch tubing
• NPTF thread standard for a pressure-tight mechanical seal
• Rated from -30 degrees F minimum to 135 degrees C maximum operating temperature
• Meets ISO 6149 and SAE J1926 standards

Compatibility

Designed as an OEM-style replacement or service component for compression fitting assemblies requiring a 1/2 inch OD Buna-N sleeve with NPTF thread interface in hydraulic and fluid transfer systems.

Installation Notes

Installation is performed by licensed plumbers or hydraulic technicians familiar with compression fitting assembly. Depressurize and drain the fluid line completely before disassembling any fitting. Use appropriate wrenches to achieve a proper mechanical seat without over-tightening, which can deform the sleeve and compromise the seal. Verify fluid compatibility with Buna-N before installation, as this material is not suitable for all chemical or high-temperature steam applications.