Panduit SE25PFR-MR0 Expandable Sleeving 0.25 Inches

Product Description

The PANDUIT SE25PFR-MR0 is an expandable wire sleeving solution designed to bundle, protect, and route cables and wiring in electrical and low-voltage installations. With a nominal diameter of 0.25 inches (6.4 mm), the sleeve expands to accept a range of bundle sizes, then contracts to hold conductors firmly in place. This type of sleeving is a standard tool for electricians and low-voltage installers who need a clean, flexible method of managing wire runs without rigid conduit. It is sold as an individual unit and is suited for both new installation and retrofit wiring projects.

Expandable sleeving at this size is commonly used in panel wiring, control cabinet harness dressing, and equipment wiring management across residential, commercial, and light industrial applications. The 0.25-inch nominal size accommodates small-diameter wire bundles typical in low-voltage control wiring, instrumentation leads, and structured cabling runs. Electricians and low-voltage technicians reach for this product when routing conductors through enclosures or along equipment frames where a professional, protected finish is required.

Key Features

• Nominal diameter of 0.25 inches (6.4 mm) for small wire bundle management
• Expandable construction allows the sleeve to open for easy cable insertion and close snugly around the bundle
• Flexible design conforms to bends and routing paths without kinking
• Provides abrasion and chafe protection along the length of the bundle
• Sold individually, allowing precise quantity purchasing per job

Compatibility

Designed as an OEM-style wire management accessory suitable for use with small wire bundles in electrical panels, control enclosures, and low-voltage wiring applications where 0.25-inch nominal expandable sleeving is specified.

Installation Notes

Expandable sleeving is typically installed by electricians or low-voltage technicians. De-energize all circuits before dressing or re-routing any wire bundle. Feed conductors into the sleeve before securing endpoints, and use manufacturer-recommended end caps or ties to prevent sleeve ends from fraying. Follow applicable NEC requirements for wiring methods when installing sleeving inside panels or enclosures.