Panduit PLT4S-C4Y Standard Cable Tie 14.5in Yellow Nylon

Product Description

The PANDUIT PLT4S-C4Y is a standard nylon cable tie designed for bundling and securing wire harnesses, cable runs, and conduit assemblies in electrical, datacom, and industrial installations. At 14.5 inches in overall length with a maximum bundle diameter of 4 inches, this tie handles mid- to large-gauge bundles with a rated tensile strength of 50 lb. The yellow color supports color-coded cable management schemes commonly used in panel wiring and raceway installations. Electricians, panel builders, and low-voltage technicians are the primary installers. The nylon construction is rated for continuous use from -76 degrees F to 185 degrees F, making it suitable for indoor and protected outdoor environments.

This cable tie is used in residential and commercial electrical panels, wire management trays, equipment racks, and conduit bundles. The 4-inch maximum bundle diameter accommodates moderate to large cable groups. The yellow color is frequently specified in control wiring applications where visual identification of circuits or systems is required. The single-piece nylon construction allows fast, tool-assisted or hand installation in tight spaces during rough-in or finish electrical work.

Key Features

• 14.5-inch overall length accommodates a wide range of bundle sizes up to 4 inches in diameter
• 50 lb tensile strength provides secure retention for mid-weight cable bundles
• Yellow color supports color-coded wire management and circuit identification
• Nylon construction rated from -76 degrees F to 185 degrees F for broad temperature service
• 0.19-inch strap width and 0.052-inch thickness for low-profile routing in tight conduit and panel spaces
• CE Certified, CSA Certified, RoHS Compliant, and UL Listed (File E56854) per UL 62275 Type 2S and 21S

Compatibility

Designed as a standard-duty cable tie suitable for general wire bundling applications in electrical, datacom, and industrial panel environments where a 14.5-inch nylon tie with a 4-inch bundle capacity is specified.

Installation Notes

Cable ties of this type are installed by electricians and low-voltage technicians and do not require special tools, though a cable tie tensioning and cut-off tool is recommended for consistent tension and flush tail removal. De-energize circuits before working inside live panels or enclosures in accordance with NFPA 70E lockout/tagout requirements. Avoid over-tightening on bundled conductors, as excessive cinch force can damage insulation on smaller gauge wire. Tails should be cut flush to prevent sharp edges that could contact adjacent conductors or cause injury.