Panduit HSTT05-48-Q6 Heat Shrink Tubing 0.05 in

Product Description

The PANDUIT HSTT05-48-Q6 is a thin-wall heat shrink tubing designed for electrical wire insulation, bundling, and strain relief in low-voltage wiring applications. With a recovered inner diameter of 0.05 inches (1.2 mm), this tubing is suited for small-gauge conductors and tight terminations where a clean, secure insulating sleeve is required. Licensed electricians and instrumentation technicians install this tubing using a heat gun to achieve a uniform shrink over splices, terminals, and wire ends. It provides environmental protection and abrasion resistance in control panel, industrial, and field wiring applications.

This heat shrink tubing is appropriate for residential and commercial electrical work, panel wiring, and instrumentation runs where small-diameter wire protection is needed. Its thin-wall construction allows for a low-profile finish on fine-gauge conductors. The 48-inch length provides sufficient material for multiple terminations or longer sleeve applications from a single piece, reducing material handling on the job.

Key Features

• Thin-wall construction provides a low-profile insulating sleeve on small-gauge conductors
• 0.05 inch (1.2 mm) recovered inner diameter sized for fine-gauge wire and terminations
• 48-inch length accommodates multiple installations from a single piece
• Applied with a standard heat gun for consistent, uniform shrink
• Provides insulation, abrasion resistance, and environmental protection at wire terminations

Compatibility

Designed as an OEM-style heat shrink sleeve for use on small-diameter electrical conductors and wire terminations requiring thin-wall insulation coverage.

Installation Notes

Installation is performed by licensed electricians or qualified technicians. De-energize and lock out all circuits before applying heat shrink tubing to any conductor or termination. Use a calibrated heat gun and apply heat evenly along the length of the tubing to achieve full shrink without scorching the sleeve or underlying conductor insulation. Follow applicable NEC requirements for insulation and wire management in the system being serviced.