Panduit FXTRL8NUSSNM014 OM3 12-fiber Harness Cable

Product Description

The PANDUIT FXTRL8NUSSNM014 is an OM3 12-fiber round harness cable assembly designed for high-density fiber optic distribution in structured cabling systems. This assembly transitions a single multi-fiber trunk cable into individual fiber legs, allowing direct patching to active equipment or patch panels. OM3 multimode fiber supports high-bandwidth applications including 10 Gigabit and 40 Gigabit Ethernet over typical enterprise and data center link distances. Structured cabling technicians and low-voltage contractors install this type of assembly in backbone and horizontal distribution runs where pre-terminated, factory-tested assemblies are preferred over field-terminated solutions.

This harness assembly is suited for use in data centers, server rooms, and enterprise network closets where OM3 multimode infrastructure is in place. The round cable construction supports organized routing through cable trays, conduit, and management hardware. It is sold individually as a single unit and is intended for installation by qualified fiber optic technicians following TIA-568 structured cabling standards.

Key Features

• OM3 multimode fiber supports 10GbE and 40GbE applications
• 12-fiber count in a single round harness cable construction
• Factory pre-terminated assembly reduces installation time and eliminates field termination errors
• Round cable jacket supports routing through conduit and cable management hardware
• Sold as a single unit (each)

Compatibility

Designed as an OEM-style replacement and standard-fit harness assembly for OM3 multimode fiber optic distribution systems using 12-fiber connectivity infrastructure.

Installation Notes

Installation should be performed by a qualified fiber optic or low-voltage cabling technician familiar with TIA-568 standards. Inspect connector end-faces with an approved fiber inspection scope before mating, and clean connectors per IEC 61300-3-35 procedures. Avoid exceeding the minimum bend radius of the cable during routing to prevent signal degradation. Do not apply excessive pull tension when routing through conduit or cable management systems.