Panduit FX8RP7NUSQNF007 OM3 8-fiber Round Harness Plenum

Product Description

The PANDUIT FX8RP7NUSQNF007 is an OM3 multimode 8-fiber round harness assembly with a plenum-rated jacket, designed for structured cabling installations in commercial and enterprise environments. This factory-terminated fiber optic harness transitions a single multi-fiber trunk cable into individual fiber legs, enabling clean, organized connections at patch panels, switches, and fiber distribution units. The plenum-rated construction meets fire and smoke requirements for air-handling spaces, making it suitable for above-ceiling and raised-floor deployments. Licensed low-voltage cabling contractors and data center infrastructure technicians are the primary installers of this assembly.

This harness assembly is used in horizontal and backbone fiber runs within commercial buildings, data centers, and campus network infrastructures. It is well suited for applications requiring OM3 50-micron multimode performance, supporting high-bandwidth protocols over short to medium distances. The round cable form factor simplifies routing through conduit and cable trays. Typical installation scenarios include structured cabling backbone runs, zone cabling distribution points, and fiber equipment room interconnects.

Key Features

• OM3 multimode fiber supports high-bandwidth data transmission over 50-micron glass
• 8-fiber count provides multiple simultaneous channel capacity in a single assembly
• Plenum-rated (CMP) jacket meets fire and smoke spread requirements for air-handling spaces
• Round cable construction for straightforward routing through conduit and cable management hardware
• Factory-terminated harness design reduces field termination time and ensures consistent performance

Compatibility

Designed as an OEM-style fiber optic harness assembly for use with OM3 multimode fiber infrastructure, including patch panels, fiber distribution units, and active equipment ports accepting the corresponding connector interface.

Installation Notes

Installation should be performed by a licensed low-voltage cabling contractor familiar with TIA-568 structured cabling standards and fiber optic handling procedures. Power down or disable active equipment ports before connecting or disconnecting fiber assemblies to prevent optical exposure hazards. Observe the manufacturer minimum bend radius throughout routing to avoid signal degradation or fiber damage. Do not exceed rated pulling tension when routing through conduit or cable trays.