Panduit FS2EPKJKJNJM007 OM4+ Duplex Lc Fiber Patch Cord

Product Description

The PANDUIT FS2EPKJKJNJM007 is a duplex OM4+ multimode fiber optic patch cord designed for high-density structured cabling environments. Built with a 1.6mm plenum-rated (OFNP) jacket and LC keyed connectors, this cord supports 10G, 40G, and 100G data center and enterprise network applications. The keyed LC connector design helps prevent mismatched connections in polarity-sensitive installations. Network technicians and low-voltage cabling contractors install this type of patch cord at fiber distribution panels, switches, and active equipment ports where reliable signal transmission and fire-code compliance are required.

This patch cord is suited for use in plenum spaces such as raised-floor data centers, above-ceiling cable runs, and other air-handling environments where OFNP-rated cables are required by code. The OM4+ multimode designation supports longer reach at higher data rates compared to standard OM4, making it appropriate for backbone or horizontal runs in high-performance structured cabling systems. The duplex configuration carries simultaneous transmit and receive paths over two fibers.

Key Features

• OM4+ multimode glass fiber supports 10G, 40G, and 100G Ethernet applications
• OFNP plenum-rated outer jacket meets fire code requirements for air-handling spaces
• LC keyed connectors reduce the risk of incorrect polarity connections in dense patching environments
• 1.6mm duplex zipcord construction provides flexibility in tight cable management spaces
• Pre-terminated factory end-faces deliver consistent insertion loss performance

Compatibility

Designed as an OEM-style replacement or new-installation patch cord compatible with standard LC-port fiber optic equipment in OM4+ multimode structured cabling systems.

Installation Notes

Installation is performed by licensed low-voltage cabling technicians or network infrastructure contractors. Inspect connector end-faces with a fiber inspection scope before mating, and clean per industry standard practices. Do not bend the cable below its minimum bend radius during routing. Plenum installations must comply with local building and fire codes referencing NEC Article 770.