Panduit FS2EPKDKDNDM007 OM4+ Duplex Fiber Patch Cord Lc

Product Description

The PANDUIT FS2EPKDKDNDM007 is a factory-terminated OM4+ duplex fiber optic patch cord designed for high-density structured cabling environments. Built with a 1.6mm jacketed construction and keyed LC connectors on both ends, this cord supports multimode transmission at extended OM4+ performance levels. The OFNP-rated jacket meets plenum fire code requirements, making it appropriate for installation in air-handling spaces and raised-floor data environments. Network technicians and low-voltage cabling contractors install this cord between active equipment and patch panels in enterprise, data center, and campus backbone applications.

This patch cord is suited for horizontal and backbone fiber runs in commercial and enterprise network installations. The keyed LC connector format is commonly used in high-density patch panels and active equipment ports where polarity management or port access control is required. The OM4+ multimode rating supports high-bandwidth applications including 40G and 100G Ethernet over supported link distances. It ships as a single unit and is appropriate for both new installations and replacement of damaged or out-of-spec cords in existing fiber infrastructure.

Key Features

• OM4+ multimode fiber supports extended bandwidth performance beyond standard OM4 specifications
• Duplex 2-fiber construction in a 1.6mm jacketed cable for reduced diameter and improved bend radius in tight pathways
• Keyed LC connectors on both ends for polarity management and controlled port access in high-density panels
• OFNP plenum-rated jacket meets NEC Article 770 requirements for installation in air-handling spaces
• Factory-terminated and tested for insertion loss and return loss compliance

Compatibility

Designed as an OEM-style replacement or new-installation patch cord for OM4+ multimode fiber optic systems using keyed LC duplex interfaces in plenum-rated structured cabling environments.

Installation Notes

Installation should be performed by a qualified low-voltage cabling technician or registered communications distributor familiar with TIA-568 fiber optic standards. Deactivate any connected transceivers and follow laser safety procedures before handling fiber ends. Avoid exceeding the minimum bend radius of the 1.6mm jacket during routing through conduit or cable managers. Inspect connector end-faces with a fiber inspection scope before mating to confirm cleanliness and prevent damage to active equipment ports.