Panduit F92EPKDKDSDM025 OS2 Duplex Fiber Patch Cord Lc

Product Description

The PANDUIT F92EPKDKDSDM025 is an OS2 single-mode duplex fiber optic patch cord designed for low-loss, high-bandwidth structured cabling installations. Constructed with a 1.6mm diameter cable jacket and terminated with LC connectors on both ends, this patch cord carries an OFNP (optical fiber nonconductive plenum) rating, making it suitable for deployment in air-handling spaces and plenum ceiling environments. The 2-fiber configuration supports full-duplex data transmission. Network technicians, data center cabling contractors, and low-voltage installers use this cord to connect fiber optic equipment, patch panels, and active network hardware.

This patch cord is designed for use in structured cabling systems that require OS2 single-mode performance. The plenum-rated jacket meets fire and smoke requirements for installation in plenum air spaces without conduit. LC-to-LC connectivity suits high-density fiber distribution frames, switches, routers, and transceivers commonly found in commercial data centers, enterprise network closets, and telecommunications rooms. The keyed connector design helps prevent mismatched polarity connections during installation.

Key Features

• OS2 single-mode fiber supports long-distance, low-attenuation transmission
• OFNP plenum-rated jacket approved for air-handling and plenum space installation without conduit
• 1.6mm duplex cable construction with 2-fiber count
• LC duplex connectors on both ends for high-density panel and equipment connections
• Keyed connector design aids polarity management and prevents mismatch
• 25-meter length suits cross-room and inter-rack runs

Compatibility

Designed as an OEM-style patch cord for use with LC-compatible fiber optic patch panels, transceivers, and active equipment in OS2 single-mode structured cabling systems.

Installation Notes

Low-voltage cabling technicians and data center installers should handle fiber connectors with care to avoid contamination of the ferrule end faces — inspect and clean connectors with approved tools before mating. Plenum installations must comply with applicable local building codes and NFPA 90A requirements for air-handling spaces. Avoid sharp bends that exceed the cable minimum bend radius, and do not overtighten cable management ties around fiber jackets. Power down active equipment ports before inserting or removing fiber patch cords where hot-swap is not supported.