Panduit CLTS35N-C Corrugated Loom Tubing 0.31 in

Product Description

The PANDUIT CLTS35N-C is a solid corrugated loom tubing section used to route, bundle, and protect wire harnesses and cable runs in electrical and low-voltage wiring applications. The solid-wall corrugated design allows the tubing to flex around bends while maintaining consistent protection against abrasion, chafing, and minor mechanical impact. With an inner diameter of 0.31 inches, this tubing is sized for smaller wire bundles commonly found in control panels, automotive wiring, and equipment harness builds. Electricians, panel builders, and harness technicians install this type of loom tubing as part of organized wire management systems.

This corrugated loom tubing is suited for use in residential and light commercial electrical panels, industrial control enclosures, and equipment wiring harnesses where cable protection and routing organization are required. The solid-wall construction differs from slit loom tubing in that cables must be fed through the tube end rather than snapped in from the side, making it appropriate for pre-assembly harness applications.

Key Features

• Solid corrugated wall construction provides consistent abrasion and chafe protection along the full length
• 0.31 inch inner diameter sized for small wire bundles and individual conductor runs
• Flexible corrugated profile allows routing around curves and through tight pathways
• Sold as an individual unit for targeted replacements or small harness builds

Compatibility

Designed as an OEM-style wire management component for use in electrical control panels, equipment wiring harnesses, and low-voltage cable routing applications requiring solid corrugated loom tubing at the 0.31 inch inner diameter size.

Installation Notes

Solid corrugated loom tubing is typically installed by electricians, panel builders, or harness technicians during initial assembly or harness rework. Power down and de-energize all circuits before working in the wiring area. Feed conductors through the tube from one end before securing connectors or terminals. Follow applicable NEC requirements for wire protection and bundling in the installation environment.