Panduit CJ6X88TGAW-24 Mini-com Module Cat 6A Utp

Product Description

The PANDUIT CJ6X88TGAW-24 is a Mini-Com snap-in keystone module rated for Category 6A unshielded twisted pair (UTP) structured cabling. It is designed to terminate horizontal copper cabling at the work area outlet, patch panel, or consolidation point within a structured wiring system. Network installers and low-voltage cabling technicians install this module into Mini-Com faceplates, surface-mount boxes, or patch panels to provide a compliant RJ-45 interface. The Cat 6A rating supports 10-Gigabit Ethernet (10GBase-T) at frequencies up to 500 MHz, making it appropriate for high-density enterprise, data center, and commercial network deployments.

This module is suited for horizontal cabling runs in commercial and enterprise environments where Cat 6A performance is required. Typical applications include office work area outlets, data center structured cabling infrastructure, and consolidation points in open-floor or ceiling plenum cable pathways. It terminates UTP cable and fits into PANDUIT Mini-Com series faceplates, surface boxes, and patch panels, allowing consistent system-level performance across the installation.

Key Features

• Category 6A UTP rating supports 10GBase-T at frequencies up to 500 MHz
• Snap-in Mini-Com module format for tool-assisted or tool-less faceplate and patch panel installation
• RJ-45 interface for standard patch cord connectivity
• Sold individually, allowing targeted replacement or incremental deployment
• Compatible with PANDUIT Mini-Com series mounting hardware for a uniform, organized appearance

Compatibility

Designed as an OEM-style snap-in replacement or new-installation component for PANDUIT Mini-Com series faceplates, surface-mount boxes, and patch panels that accept standard Mini-Com keystone modules.

Installation Notes

Installation should be performed by a qualified low-voltage cabling technician following TIA-568 structured cabling standards. De-energize any powered patch panels or active equipment at the termination point before beginning work. Use a 110-style punch-down tool or the manufacturer-recommended termination tool to seat conductors fully before trimming. Avoid untwisting UTP pairs more than is required by the connector manufacturer, as excess untwisting degrades Cat 6A performance at high frequencies.