Panduit BR-4.0-1/4-20 Bridle Ring 4 Inch 1/4-20

Product Description

The PANDUIT BR-4.0-1/4-20 is a bridle ring designed to support and route cables, conduit, and wire bundles in electrical and low-voltage installations. With a 4-inch inside diameter, the ring accommodates larger cable bundles or single larger conduit runs. The 1/4-20 threaded stud mounting makes it compatible with standard threaded rod and beam clamp assemblies commonly used in commercial and industrial raceways. Licensed electricians and low-voltage installers use bridle rings as a fast, code-friendly method to support cables along runs between fixed anchor points.

This bridle ring is suited for commercial, industrial, and institutional installations where cable management along threaded rod drops or structural support systems is required. It works in suspended ceiling spaces, open plenum areas, and exposed structural runs. The 4-inch diameter makes it practical for routing grouped Category cabling, coaxial bundles, fiber conduit, or multi-conductor wire in a single support point rather than stacking multiple smaller rings.

Key Features

• 4-inch inside diameter accommodates large cable bundles or single larger conduit runs
• 1/4-20 threaded stud for direct attachment to standard threaded rod assemblies
• Sold individually, allowing quantity to match exact job requirements
• Hardware accessory category — suitable for structured wiring and electrical support applications

Compatibility

Designed as an OEM-style cable management accessory for use with standard 1/4-20 threaded rod support systems in commercial and industrial electrical installations.

Installation Notes

Bridle rings are installed by licensed electricians or low-voltage technicians in accordance with NEC Article 300 support and securing requirements. De-energize all circuits in the work area before routing or repositioning cables through the ring. Thread the stud onto an existing threaded rod or beam clamp assembly and tighten with the appropriate wrench before loading cables. Do not exceed the rated cable fill or apply lateral loads that could bend the stud.