Osg VGM7-0060 Square End Mill 1/2 in 7 Flute Carbide

Product Description

The OSG VGM7-0060 is a solid carbide square end mill designed for high-performance milling applications in metalworking and machining environments. Measuring 0.5 inches in cutting diameter with a 1-inch length of cut, this tool runs a 7-flute, helical geometry at a 36-degree helix angle. The variable index flute spacing reduces harmonic vibration during aggressive cuts. An EXO coating provides surface hardness and heat resistance for extended tool life in ferrous and hard materials. This end mill is installed by machinists and CNC tool-setup technicians in production and job-shop environments.

This end mill suits single-end milling operations requiring a stub-length configuration and straight cylindrical shank. The right-hand cut and right-hand flute orientation are standard for conventional CNC machining centers and manual knee mills. With a 0.5-inch shank diameter and 3-inch overall length, it fits standard ER collet chucks and end mill holders commonly found in production shops. The 7-flute count makes it most effective in finishing passes and semi-finishing cuts in materials where chip room per flute is less critical than surface finish quality.

Key Features

• 7-flute helical geometry at 36-degree helix angle for reduced vibration and improved finish
• Variable index flute spacing minimizes chatter during high-feed operations
• EXO coating delivers elevated surface hardness and thermal resistance
• Micrograin solid carbide construction for rigidity and edge retention
• Straight cylindrical shank fits standard collet and end mill holder systems
• Single-end, non-centercutting design — not intended for plunge entry

Compatibility

Designed for use in standard 1/2-inch bore ER collet chucks and end mill holders on CNC machining centers and manual mills. Part of the OSG VGM7 series.

Installation Notes

Installation is performed by a machinist or CNC setup technician. Ensure the machine spindle is fully stopped and power is locked out before changing tooling. Seat the shank fully and evenly in the collet or holder before torquing retention hardware to the machine manufacturer's specification. This tool is not centercutting — do not use for direct plunge entry without a pre-drilled pilot hole or ramping strategy.