Oregon Tool S50 Advancecut 14 Inch Chainsaw Chain

Product Description

The OREGON TOOL S50 is a 14-inch semi-chisel chainsaw chain built for consistent cutting performance on small to mid-size gas saws. It features a hard-chromed cutter with precision heat treatment, delivering a smooth cut even when debris is present in the wood. The chain runs on a 3/8-inch pitch and 0.050-inch gauge, making it compatible with a wide range of consumer and light-duty professional saws up to 42 cc. Hardened rivets and the chrome outer layer reduce wear over time, helping extend service intervals. The built-in Lubri-Tec oiling system channels bar oil to critical chain contact points during operation, cutting down on dry-running wear and maintenance downtime.

The S50 is designed for landscapers, grounds maintenance crews, and homeowners who run small, lower-powered chainsaws. Typical applications include limbing, bucking small-diameter logs, brush clearing, and general property maintenance. The low-kickback, low-vibration design reduces user fatigue during extended cutting sessions, making it well suited for repetitive cutting tasks. This chain is intended for use with narrow-kerf guide bars only and should not be paired with standard-kerf bar designs.

Key Features

• Hard-chromed semi-chisel cutters provide higher tolerance for dirt and debris in the cut
• 3/8-inch pitch and 0.050-inch gauge fit a broad range of saws up to 42 cc
• Built-in Lubri-Tec automatic oiling system delivers oil to key chain contact points
• Low-kickback, low-vibration design reduces operator fatigue during extended use
• Hardened rivets and chrome outer layer minimize chain stretch and wear
• Meets ANSI standards for chainsaw chain safety

Compatibility

Designed for all chainsaw brands running a 3/8-inch pitch and 0.050-inch gauge. Suitable for saw engines up to 42 cc. Must be used with narrow-kerf guide bars only.

Installation Notes

Chain installation and tensioning should be performed by a qualified technician or experienced operator with the saw engine off, the ignition disabled, and cut-resistant gloves on. Verify bar groove width matches the 0.050-inch gauge before fitting. After installation, check tension and confirm the drive links seat properly in the bar groove before first use. Always consult the saw manufacturer's service manual and applicable ANSI B175.1 guidelines for chain replacement procedures.

Technical Specifications

• Bar Length: 14 inches
• Pitch: 3/8 inch
• Gauge: 0.050 inch (1.3 mm)
• Cutter Type: Semi-chisel
• Cutter Finish: Hard chrome
• Oiling System: Lubri-Tec built-in automatic
• Max Engine Size: 42 cc
• Kerf Type: Narrow kerf
• Certifications: ANSI compliant
• Weight: 0.506 pounds
• Sold As: Each

Standard Information

• Brand: OREGON TOOL
• Manufacturer Part Number: S50