Optex CA-1W(W) Multi Angle Wall Bracket Photo Beams

Product Description

The OPTEX CA-1W(W) is a multi-angle wall bracket designed to mount photo beam sensors and detectors to wall surfaces. It provides adjustable positioning to achieve the correct beam alignment during installation. This bracket is used in security, access control, and detection system setups where precise sensor orientation is required. Technicians and integrators install this hardware during initial system deployment or when repositioning existing photo beam units. The bracket ships as a single unit and is compatible with OPTEX photo beam product lines.

This wall bracket is suited for both indoor and outdoor photo beam installations where wall-mounting is the preferred or required mounting method. It is commonly used in commercial security perimeter systems, gate access applications, and industrial detection setups. The adjustable angle design allows the installer to fine-tune the beam path without relocating the mounting point, reducing installation time on the job.

Key Features

• Multi-angle adjustment allows precise beam alignment after mounting
• Wall-mount design keeps sensors secure and properly positioned
• Compatible with OPTEX photo beam sensor series
• Single-unit packaging for straightforward procurement and inventory

Compatibility

Designed for use with OPTEX photo beam sensors and detectors. Refer to OPTEX product documentation to confirm fitment with specific sensor models in your installation.

Installation Notes

Installation is typically performed by a licensed security or low-voltage technician. Disconnect power to the photo beam system before mounting or adjusting the bracket. Secure the bracket to a structurally sound wall surface using fasteners appropriate for the substrate. Confirm beam alignment and sensor operation after installation before returning the system to service.