Norton 66623325046 Quick-change Disc 1 in Aluminum Oxide

Product Description

The NORTON 66623325046 is a 1-inch diameter, non-woven quick-change disc designed for surface conditioning, weld blending, and finishing work across a wide range of metals. Part of the Bear-Tex Rapid Prep series, it uses a Type S (TS Type II) attaching system for fast, tool-free mounting. The disc is built on a flexible nylon web backing with Vortex agglomerated aluminum oxide grain held in place with proprietary Clean Bond resin technology. At a Very Fine grade (500 grit) and rated for up to 40000 RPM, it delivers consistent, controlled surface finish without aggressive stock removal. Licensed HVAC technicians, plumbers, pipefitters, and metal fabricators will find it suited to light deburring, blending, and prep work.

The 66623325046 is intended for use with handheld disc sanders and straight grinders. Its flexible nylon web construction makes it effective on contoured surfaces and tight areas. The disc handles a broad spectrum of materials including 300 and 400 Series Stainless Steel, brass, bronze, copper, cast iron, ductile iron, gray iron, hard and soft carbon steels, super alloys, titanium, tool steels, and fiberglass and composites. The small 1-inch diameter suits close-clearance applications where larger discs cannot reach.

Key Features

• TS Type II quick-change compatibility with Type S attaching system for tool-free disc swaps
• Vortex agglomerated aluminum oxide grain for consistent cut rate on hard and soft metals
• High-loft flexible nylon web backing conforms to curved and irregular surfaces
• Proprietary Clean Bond resin technology extends disc life and maintains grain exposure
• Very Fine grade (500 grit) suited to weld blending and finishing passes
• Rated to 40000 RPM for use with handheld disc sanders and straight grinders

Compatibility

Designed for use with handheld disc sanders and straight grinders that accept a TS Type II (Type S) quick-change interface. Compatible material applications include 300 Series Stainless, 400 Series Stainless, brass, bronze, cast iron, copper, ductile iron, fiberglass and composites, gray iron, hard carbon steels, soft carbon steels, super alloys, titanium, and tool steels.

Installation Notes

Disc installation and removal should be performed with the tool powered off and disconnected from its power source. Align the disc button with the tool arbor and press firmly until it seats securely before operation. Do not exceed the rated maximum RPM of 40000. Inspect the disc for damage before each use and replace immediately if tears, delamination, or unusual wear are observed.