Norton 66261080266 Deburring Wheel 3 in Aluminum Oxide

Product Description

The NORTON 66261080266 is a unitized deburring wheel designed for edge finishing, light deburring, and surface blending on metal workpieces. Built with aluminum oxide abrasive at a medium grade and density 7 construction, this wheel delivers consistent, controlled cut action through its full service life. The unitized build bonds abrasive fibers throughout the entire wheel body, so performance stays predictable as the wheel wears down. At 3 inches in diameter with a 1/2-inch face width and a 3/8-inch center hole, it fits a wide range of small-to-mid-size powered grinders used in fabrication, maintenance, and machine shop work.

This deburring wheel is suited for bench grinder, die grinder, pedestal grinder, and inline or straight grinder setups. It is commonly used in metal fabrication shops, maintenance facilities, and production environments where consistent edge preparation or surface conditioning is required. The 3/8-inch arbor bore makes it compatible with standard spindle sizes found on bench and die grinders. Technicians and machinists reach for this wheel when removing sharp burrs from drilled, milled, or cut metal parts without significantly altering part geometry.

Key Features

• Aluminum oxide abrasive construction for reliable cut rate on ferrous and non-ferrous metals
• Medium grade, density 7 unitized wheel maintains consistent performance throughout wheel life
• 3 inch diameter by 1/2 inch face width suits compact grinder setups
• 3/8 inch center hole fits standard bench grinder and die grinder arbors
• Compatible with bench grinders, die grinders, pedestal grinders, pencil grinders, flexible shaft grinders, inline grinders, and straight grinders

Compatibility

Compatible with bench grinders, die grinders, flexible shaft grinders, inline grinders, pedestal grinders, pencil grinders, and straight grinders with a 3/8-inch spindle arbor.

Installation Notes

Always power down and unplug or lock out the grinder before mounting or removing any abrasive wheel. Verify that the arbor bore matches the spindle diameter and that all flanges and guards are properly seated before starting the tool. Inspect the wheel for cracks or damage before each use and never operate above the rated RPM marked on the wheel or packaging. Abrasive wheel mounting and use is subject to ANSI B7.1 safety standards and applicable shop safety codes.