Norton 66261058518 Deburring Wheel 8 Inch Silicon Carbide

Product Description

The NORTON 66261058518 is a convolute deburring wheel designed for edge blending, deburring, and surface conditioning on metal workpieces. Built with silicon carbide abrasive at a medium grade and density 4 construction, it delivers consistent, controlled material removal without aggressive stock loss. The convolute construction bonds abrasive grain throughout layers of non-woven material, maintaining an open structure that resists loading during extended use. This wheel is suited for metalworking shops, fabrication facilities, and maintenance operations where clean, deburred edges are required before finishing or assembly.

This deburring wheel is used on bench grinders and pedestal grinders in industrial and trade shop settings. It is appropriate for deburring ferrous and non-ferrous metals, cleaning welds, and light surface blending. The 8-inch diameter and 1-inch face width make it a standard fit for typical bench grinder arbor setups. The 3-inch center hole accommodates standard pedestal grinder arbors commonly found in fabrication and maintenance environments. Machinists, fabricators, and maintenance technicians are the primary users.

Key Features

• Silicon carbide abrasive material for effective deburring on a wide range of metals
• Medium grade, density 4 convolute construction for controlled, consistent cut rate
• 8-inch diameter with 1-inch face width for broad contact on bench and pedestal grinders
• 3-inch center hole fits standard pedestal grinder arbors
• Rated to 2,500 RPM maximum operating speed
• Compatible with bench grinders and pedestal grinders

Compatibility

Designed for use on bench grinders and pedestal grinders. The 3-inch center hole and 8-inch wheel diameter fit standard arbor configurations on these machine types.

Installation Notes

Installation should be performed by a qualified operator familiar with abrasive wheel mounting procedures. Power down and lock out the grinder before mounting or removing the wheel. Inspect the wheel for cracks or damage before installation and run the grinder at operating speed with a guard in place before presenting work. Always operate at or below the 2,500 RPM maximum rated speed marked on the wheel.