Norton 66261009186 Quick-change Disc 3 in Aluminum Oxide

Product Description

The NORTON 66261009186 is a 3-inch non-woven aluminum oxide quick-change disc designed for surface conditioning, blending, and finishing on a wide range of metals. It uses a Type S Speed-Lok TS attachment system for fast, tool-free mounting on compatible handheld disc sanders. The disc is built on a polyester and nylon web backing with a rigid, high-loft nylon fiber construction. Coarse grade aluminum oxide grain and Clean Bond resin technology allow moderate material removal while leaving a smear-free finish. Rated to 20000 RPM, this disc is suitable for demanding shop and field work performed by metal fabricators, pipefitters, and maintenance technicians.

This disc is suited for use on a broad range of materials including 300 and 400 series stainless steel, brass, bronze, cast iron, copper, ductile iron, fiberglass and composites, gray iron, hard and soft carbon steels, super alloys, titanium, and tool steels. It is intended for use with handheld disc sanders that accept Speed-Lok TS Type S quick-change accessories. Typical applications include weld blending, surface prep before coating, deburring, and light stock removal in fabrication, maintenance, and repair environments.

Key Features

• Type S Speed-Lok TS attachment for tool-free disc changes on compatible sanders
• Aluminum oxide abrasive grain with coarse grade for moderate material removal
• High-loft nylon fiber construction extends disc service life
• Clean Bond resin technology delivers smear-free finishes on metal surfaces
• Rigid backing provides consistent contact and controlled cut rate
• Rated to 20000 RPM for use at standard handheld sander operating speeds

Compatibility

Designed for use with handheld disc sanders that accept Speed-Lok TS Type S quick-change discs. Compatible material applications include 300 Series Stainless, 400 Series Stainless, Brass, Bronze, Cast Iron, Copper, Ductile Iron, Fiberglass and Composites, Gray Iron, Hard Carbon Steels, Soft Carbon Steels, Super Alloys, Titanium, and Tool Steels.

Installation Notes

Mounting and disc changes should be performed with the sander powered off and disconnected from its power source. Verify that the sander spindle accepts the Speed-Lok TS Type S attachment before installing. Do not exceed the 20000 RPM maximum disc speed rating. Inspect the disc for damage before each use and discard any disc that shows tears, delamination, or uneven wear.