Norton 66253022703 Cut-off Wheel 8 in Steel

Product Description

The NORTON 66253022703 is a Type 1 (01/41) resinoid-bonded aluminum oxide cut-off wheel designed for aggressive cutting on steel and stainless steel. Measuring 8 inches in diameter and 1/16 inches thick with a 5/8 inches arbor hole, it is rated to a maximum of 7,640 RPM and carries a 36-grit, hardness code T rating for fast, controlled cuts through ferrous and stainless material. Both sides are reinforced for added burst resistance under load. This wheel is intended for use with circular saws and is a standard consumable stocked and replaced by metalworking tradespeople, fabricators, and maintenance technicians.

This cut-off wheel is suited for straight cutting operations on steel and stainless steel in both shop and field applications. Typical use cases include pipe cutting, structural steel fabrication, sheet metal work, and maintenance cutting tasks where a circular saw is the tool of choice. The 8 inches diameter and thin 1/16 inches kerf minimize material loss and heat buildup during the cut, making it practical for tight tolerances and finish-sensitive stainless steel work.

Key Features

• 8 inches diameter, 1/16 inches thick Type 1 (01/41) flat profile for straight plunge and chop cuts
• Aluminum oxide abrasive grain, 36 grit, hardness code T for aggressive stock removal on ferrous metals
• Resinoid bond with grain structure 4 for consistent cut performance and wheel integrity
• Both sides reinforced for improved safety and burst resistance at operating speed
• 5/8 inches arbor hole fits standard circular saw spindles
• 7,640 maximum RPM rating — verify tool speed does not exceed this limit before mounting

Compatibility

Rated for use with circular saws cutting steel and stainless steel. Fits spindles with a 5/8 inches arbor. Confirm the tool's no-load RPM does not exceed 7,640 RPM before mounting.

Installation Notes

Mounting and replacement of abrasive cut-off wheels should be performed by a qualified operator familiar with ANSI B7.1 safe-use standards for abrasive wheels. Power down and disconnect or lock out the circular saw before changing wheels. Inspect the wheel for cracks, chips, or damage before each use — do not mount a damaged wheel. Always verify the tool's rated RPM does not exceed the wheel's 7,640 RPM maximum before operation.