Norton 66252922683 Cut-off Wheel 7in Aluminum Oxide 60 Grit

Product Description

The NORTON 66252922683 is a 7-inch aluminum oxide cut-off wheel designed for precision cutting on steel and stainless steel. It measures 7 inches in diameter, 1/16 inch thick, with a 1-1/4 inch arbor hole. The wheel uses a shellac bond and carries a Type 1 (flat) profile, rated to a maximum of 5185 RPM. At 0.3 pounds, it is lightweight and suited for use with stationary cutting tools. The 60-grit aluminum oxide abrasive delivers consistent material removal on ferrous and stainless metals in fabrication and repair environments. Licensed tradespeople and metalworking professionals are the primary installers and operators of this product.

This cut-off wheel is intended for use with stationary tools in applications involving steel and stainless steel cutting. Typical use cases include metal fabrication shops, maintenance and repair operations, and structural steel work where a thin-kerf, non-reinforced wheel is appropriate. The Type 1 flat geometry is compatible with stationary chop saws and abrasive cut-off machines fitted with the correct arbor size. The 60-grit rating makes it suitable for general-purpose cutting rather than fine finishing work.

Key Features

• 7-inch diameter with 1/16-inch thickness for thin-kerf cuts that minimize material loss
• 60-grit aluminum oxide abrasive rated for steel and stainless steel applications
• Shellac bond construction, Type 1 (01/41) flat wheel profile
• 1-1/4 inch arbor hole fits standard stationary cut-off machine spindles
• 5185 RPM maximum speed rating for stationary tool use
• Non-reinforced construction — suitable for dedicated stationary machines, not angle grinders

Compatibility

Designed for use with stationary abrasive cut-off tools equipped with a 1-1/4 inch arbor. Rated for cutting steel and stainless steel. Non-reinforced construction limits this wheel to stationary machine use only.

Installation Notes

This wheel must be mounted only on stationary cut-off machines — never on portable angle grinders, as the non-reinforced construction is not rated for handheld use. Before mounting, power down and lock out the machine per applicable OSHA lockout/tagout procedures. Verify that the machine spindle speed does not exceed 5185 RPM and that the arbor and flanges are clean, undamaged, and correctly sized. Inspect the wheel for cracks or chips before each use and discard any damaged wheels immediately.