Norton 66252843251 Cut-off Wheel 14 in Type 1 Zirconia

Product Description

The NORTON 66252843251 is a Type 1 flat cut-off wheel designed for aggressive cutting on steel and stainless steel in stationary tool applications. Built with zirconia alumina abrasive at 30 grit and bonded with a resinoid bond, this wheel delivers consistent stock removal on tough metals. It measures 14 inches in diameter, 1/8 inch thick, with a 1-inch arbor hole. Rated to a maximum of 4365 RPM, it is reinforced on both sides for added structural integrity during high-load stationary cutting operations. The BlueFire designation indicates a self-sharpening grain structure suited for ferrous metal cutting. Weight is approximately 2.07 pounds.

This cut-off wheel is intended for use with stationary cutting tools such as chop saws and abrasive cutoff machines. It is well suited for fabrication shops, ironworkers, pipefitters, and maintenance trades that regularly cut structural steel, pipe, angle iron, and stainless steel stock. The 14-inch diameter and 1-inch arbor hole fit standard stationary abrasive saw spindles. Applications include cutting mild steel bar stock, steel tubing, and stainless steel components where clean, controlled cuts are required.

Key Features

• Zirconia alumina abrasive grain for fast, consistent cuts on ferrous metals
• 30 grit for aggressive material removal on steel and stainless steel
• Resinoid bond provides durability and heat resistance during extended cuts
• Both sides reinforced for structural stability at rated operating speeds
• Type 1 flat profile compatible with standard stationary abrasive cutoff saws
• 4365 RPM maximum speed rating for stationary tool use

Compatibility

Designed for use with stationary abrasive cutoff tools. Rated for cutting steel and stainless steel. Suitable for machines accepting a 14-inch diameter, Type 1 wheel with a 1-inch arbor hole.

Installation Notes

Installation and wheel changes must be performed by a qualified operator following ANSI B7.1 safety requirements for abrasive wheels. Always power down and disconnect the machine before mounting or removing any abrasive wheel. Inspect the wheel for cracks or chips before mounting, and verify the machine spindle speed does not exceed the 4365 RPM maximum rating stamped on the wheel. Use the correct flanges and blotters as specified by the tool manufacturer.