Norton 66252822954 Cutoff Wheel 6 in Aluminum Oxide 90G

Product Description

The NORTON 66252822954 is a Type 1 (01/41) flat cutoff wheel designed for precision parting and slotting operations on stationary tools. It measures 6 inches in diameter and 0.02 inches thick, with a 1-1/4 inch arbor hole. The abrasive material is aluminum oxide at 90 grit, bonded with a rubber bond and rated to a maximum of 6,370 RPM. The non-reinforced construction and thin profile minimize material loss and heat buildup at the cut zone. This wheel is intended for use on stationary cutoff machines in metalworking and fabrication environments.

This cutoff wheel is suited for cutting steel and stainless steel in shop and production settings. The 6-inch diameter and 0.02-inch thickness make it appropriate for stationary bench or pedestal cutoff machines where controlled, repeatable cuts are required. Metal fabricators, maintenance technicians, and industrial tradespeople working with ferrous and stainless stock will find this wheel well matched to parting and slotting tasks at the machine.

Key Features

• 6-inch diameter with 0.02-inch thin profile for minimal kerf and reduced material waste
• Aluminum oxide abrasive at 90 grit for controlled cutting on steel and stainless steel
• Rubber bond construction rated to 6,370 RPM maximum
• Type 1 (01/41) flat wheel geometry for straight parting cuts on stationary tools
• Non-reinforced design suited to stationary machine use rather than portable grinders
• 1-1/4 inch arbor hole fits standard stationary cutoff machine spindles

Compatibility

Designed for use with stationary cutoff tools. Rated for applications on steel and stainless steel. Verify that the machine spindle speed does not exceed the 6,370 RPM maximum rating before mounting.

Installation Notes

Installation should be performed by a qualified operator following the machine manufacturer's instructions and applicable ANSI B7.1 safety standards for abrasive wheels. Power down and lock out the machine before mounting or removing the wheel. Inspect the wheel for cracks or chips before each use and never operate above the marked maximum RPM. Non-reinforced wheels must not be used on portable angle grinders or in applications involving lateral grinding pressure.