Norton 63642502680 Flap Wheel 60 Grit 6x1 in Aluminum Oxide

Product Description

The NORTON 63642502680 is an unmounted aluminum oxide flap wheel designed for aggressive material removal and surface finishing on metal, wood, and composites. At 6 inches in diameter and 1 inch wide with a 60 grit rating, this medium-grade abrasive delivers consistent stock removal and blending performance on portable or stationary grinders and finishing machines. The 1 inch center hole allows direct mounting on compatible spindle arbors. A maximum operating speed of 6,200 RPM keeps the wheel rated for sustained production use. Metal fabricators, welders, and finishing technicians are the primary installers and users of this product.

This flap wheel is suited for deburring, blending weld seams, and surface conditioning on flat or contoured workpieces. The 60 grit aluminum oxide construction handles medium-grade cutting tasks where a balance of cut rate and surface finish is needed. It is appropriate for use in light manufacturing, fabrication shops, and maintenance environments where unmounted flap wheels are run on bench grinders, drill presses, or finishing lathes with compatible arbor setups.

Key Features

• Aluminum oxide abrasive for consistent cut and durability on metal and wood surfaces
• 60 grit medium grade balances material removal rate with surface finish quality
• 6 inch diameter by 1 inch wide profile suits a range of bench and spindle applications
• 1 inch center hole for direct arbor mounting without additional adapters on compatible machines
• 6,200 maximum RPM rating supports sustained production use
• Unmounted design with no interleaf for straightforward replacement and setup

Compatibility

Designed as a direct-fit unmounted flap wheel for bench grinders, finishing lathes, and drill press spindles equipped with a 1 inch arbor. Confirm machine spindle speed does not exceed 6,200 RPM before use.

Installation Notes

Installation should be performed by a qualified operator familiar with abrasive wheel mounting procedures. Always power down and disconnect the machine from its power source before mounting or removing the wheel. Inspect the wheel for cracks or damage before each use, and ensure the arbor and flanges are clean and properly sized for a 1 inch bore. Never exceed the 6,200 RPM maximum operating speed marked for this wheel.