Norgren C24670618 Swivel Tee Adapter 3/8 in Od Brass

Product Description

The NORGREN C24670618 is a brass push-to-connect swivel tee adapter designed for pneumatic and general-purpose fluid control lines. It combines tube-to-tube and male NPT connections in a single tee body, allowing a branch takeoff without additional fittings or tools. The fitting accepts 3/8-inch OD tubing on both tube ports via push-to-connect retention, while the male branch port is 1/8-inch NPTF thread. Rated to 150 psi maximum working pressure, it is suited for compressed-air distribution, instrument tubing, and light hydraulic branch circuits. HVAC controls technicians, instrumentation techs, and plumbers install this fitting in control panels and equipment manifolds.

The C24670618 is intended for general-purpose pneumatic and fluid systems operating between 0 degrees F and 175 degrees F. The swivel tee design is especially useful in confined or angled installations where a fixed tee would create alignment problems. It is appropriate for residential and light commercial applications where 3/8-inch OD tubing feeds branch circuits requiring a 1/8-inch male NPT port for gauges, solenoids, or control valves.

Key Features

• Push-to-connect tube retention on both tube ports — no ferrules or wrenches required for tubing connection
• Swivel tee body allows rotational adjustment after initial installation for better alignment
• Brass construction provides corrosion resistance in air and water service
• Nitrile O-ring seals rated for general-purpose pneumatic and fluid media
• 150 psi maximum working pressure for compressed-air and low-pressure fluid lines
• 1/8-inch NPTF male branch thread for secure, dryseal connection to ported equipment

Compatibility

Designed as an OEM-style push-to-connect swivel tee adapter for general-purpose pneumatic and fluid control systems using 3/8-inch OD tubing and 1/8-inch NPTF male ported components.

Installation Notes

A licensed HVAC controls technician or qualified plumber should install this fitting. Depressurize and bleed the line completely before disconnecting or installing any push-to-connect component. Hand-tighten the NPTF male thread into the mating port, then wrench-tighten to achieve a dryseal — do not overtighten brass threads. Insert tubing straight and fully into the push-to-connect port until it seats against the internal stop before pressurizing the line.