Norgren C24670428 Swivel Tee Adapter 1/4in Od Brass

Product Description

The NORGREN C24670428 is a brass push-to-connect swivel tee adapter designed for pneumatic and general-purpose fluid line applications. It combines a tube-to-male NPT fitting configuration in a tee layout, allowing a branch connection off an inline run without additional fittings or tools. The push-to-connect ends accept 1/4-inch outside diameter tubing, while the male branch port is threaded 1/4-inch NPTF for a leak-resistant seal. Rated to 150 psi maximum working pressure and suitable for temperatures from 0 degrees F to 175 degrees F, this fitting handles typical compressed air and light fluid service in commercial and industrial environments. Licensed trade professionals and experienced technicians install this type of fitting.

The C24670428 is suited for general-purpose pneumatic systems, compressed air distribution, and light-duty fluid circuits where a reliable tee branch connection is required. The swivel feature on the tee allows rotational adjustment during installation, making it easier to align tubing runs in tight or congested panel or cabinet spaces. It is commonly used in HVAC control systems, pneumatic actuator lines, and light industrial equipment where 1/4-inch OD tubing is standard. The nitrile O-ring internal seal contributes to consistent performance across a range of media compatible with nitrile elastomers.

Key Features

• Push-to-connect ends accept 1/4-inch OD tubing with no tools required for insertion
• Swivel tee design allows rotational positioning for easier routing in confined spaces
• Brass body construction for durability in compressed air and light fluid service
• NPTF threaded male port provides a pressure-tight mechanical seal
• Nitrile O-ring seals rated for general-purpose pneumatic media
• Maximum working pressure of 150 psi with operating range of 0 degrees F to 175 degrees F

Compatibility

Designed for general-purpose pneumatic and fluid systems using 1/4-inch outside diameter tubing and 1/4-inch NPTF male-threaded ports. Connection type is Tube x MNPT x Tube x Male.

Installation Notes

Installation should be performed by a qualified technician familiar with pneumatic fittings and applicable codes. Depressurize and isolate the line completely before removing or installing any fitting. Ensure tubing is cut cleanly and squarely and is free of burrs before inserting into push-to-connect ends to achieve a proper seal. Do not exceed the rated working pressure of 150 psi, and verify that the tubing material and O-ring compatibility are appropriate for the specific media in the system.