Norgren C24670218 Swivel Tee Adapter 5/32 in Od Brass

Product Description

The NORGREN C24670218 is a brass push-to-connect swivel tee adapter designed for pneumatic and general-purpose fluid line assemblies. It provides a three-way connection combining two push-to-connect tube ports with a male NPTF threaded port, allowing quick tube insertion without additional tools on the tube side. Rated to 150 psi maximum working pressure, this fitting accommodates 5/32-inch outside diameter tubing and a 1/8-inch NPTF male thread. The nitrile O-ring seals the push-to-connect interface and supports a working temperature range of 0 to 175 degrees F. Licensed tradespeople and OEM assembly technicians install this type of fitting in compressed air, instrumentation, and light fluid distribution systems.

This fitting is suited for residential and light commercial applications where a compact, serviceable tee connection is needed without soldering or flaring. The swivel feature on the threaded port simplifies alignment during installation, reducing stress on adjacent tubing runs. It is commonly used in pneumatic control circuits, HVAC pneumatic actuator lines, and general-purpose compressed air distribution panels where 5/32-inch OD tubing is routed to a threaded port on a valve, manifold, or instrument.

Key Features

• Push-to-connect tube ports accept 5/32-inch OD tubing with no tools required for insertion
• 1/8-inch NPTF male threaded port provides a pressure-tight connection to standard NPT fittings
• Swivel design on the threaded port eases alignment and reduces installation stress on tubing
• Rated to 150 psi maximum working pressure
• Nitrile O-ring sealing for reliable performance across a broad temperature range
• Brass construction for corrosion resistance in air and compatible fluid service

Compatibility

Designed for general-purpose pneumatic and fluid line service with 5/32-inch OD tubing and 1/8-inch NPTF male-threaded ports. Verify thread type and tubing material compatibility before installation.

Installation Notes

Depressurize and isolate the pneumatic or fluid circuit completely before removing or installing any fittings. Insert tubing straight and fully into the push-to-connect port until it seats against the internal stop; confirm a secure connection by pulling back on the tube before returning the line to service. The NPTF thread is a dryseal design, but applying an appropriate thread sealant per the system manufacturer guidance is common practice. This work is typically performed by licensed HVAC technicians, instrumentation mechanics, or plumbers working under applicable mechanical codes.