Norgren 124250116 Push-to-connect Male Adapter 1/8 Od

Product Description

The NORGREN 124250116 is a straight push-to-connect male adapter fitting in the Pneufit line, designed for fast, tool-free tube connections in pneumatic plumbing systems. It accepts 1/8-inch OD tubing on the push-to-connect end and terminates in a 1/16-inch NPTF male thread. The body is nickel-plated brass, rated to 260 psi maximum working pressure. Suitable for general-purpose pneumatic circuits, this fitting is installed by pipefitters, pneumatic system technicians, and HVAC controls specialists working with small-bore air lines and instrumentation tubing.

This adapter is used in light industrial and commercial pneumatic plumbing applications where a permanent, vibration-resistant push-to-connect joint is needed at a threaded port. It handles operating temperatures from -4 degrees F to 175 degrees F and carries a vacuum rating of 29.5 inches Hg, making it appropriate for both pressure and light vacuum service in general-purpose pneumatic circuits. The compact overall length of 0.8 inches suits installations in tight manifold or valve body assemblies where space is limited.

Key Features

• Push-to-connect design for fast, tool-free 1/8-inch OD tube insertion
• 1/16-inch NPTF male thread for leak-resistant tapered pipe thread connections
• Nickel-plated brass construction resists corrosion in typical pneumatic environments
• 260 psi maximum working pressure for general-purpose compressed air service
• Vacuum-rated to 29.5 inches Hg for combined pressure and vacuum circuit use
• Compact 0.8-inch overall length fits tight manifold and valve body ports

Compatibility

Designed for general-purpose pneumatic plumbing systems using 1/8-inch OD tubing and 1/16-inch NPTF male-threaded ports. Suitable for use with standard polyurethane, nylon, and similar push-to-connect compatible tubing materials in light industrial and commercial pneumatic circuits.

Installation Notes

Depressurize and isolate the pneumatic circuit completely before removing or installing any fittings. Ensure the tubing cut is clean and square before inserting into the push-to-connect end to achieve a proper seal. Apply appropriate thread sealant or PTFE tape to the NPTF threads per shop practice, and do not overtighten the threaded end into the receiving port. Follow applicable pneumatic plumbing codes and equipment manufacturer guidelines for maximum system pressure ratings.