Norgren 100291200 Bulkhead Connector M24x1.5 260 Psi

Product Description

The NORGREN 100291200 is a push-to-connect bulkhead tube-to-tube fitting designed to pass pneumatic or fluid lines through a panel or bulkhead wall in a single, secure connection. Constructed from nickel-plated brass, it delivers a maximum working pressure of 260 psi with an M24x1.5 thread for panel mounting. The push-to-connect ends accept 12 mm outside diameter tubing, eliminating the need for threaded ferrules or additional fittings on the tube side. At an overall length of 39.50 mm, it fits compact panel installations where space is limited. Licensed HVAC, plumbing, and pneumatic system technicians use this fitting in general-purpose fluid and air control assemblies.

This fitting is suited for general-purpose pneumatic and fluid-transfer applications in both light industrial and commercial environments. It is designed to mount through a panel or enclosure wall, routing 12 mm OD tubing from one side to the other with a bulkhead-style seal. The nitrile O-ring construction supports a working temperature range of 0 degrees F to 175 degrees F, making it appropriate for standard indoor compressed-air systems, pneumatic control panels, and similar service environments where moderate pressure and temperature conditions apply.

Key Features

• Push-to-connect ends accept 12 mm outside diameter tubing — no ferrules required
• M24x1.5 thread for secure bulkhead panel mounting
• Nickel-plated brass body resists corrosion in general-purpose service
• Rated to 260 psi maximum working pressure
• Nitrile O-ring seals rated from 0 degrees F to 175 degrees F
• Compact 39.50 mm overall length suits tight panel installations

Compatibility

Designed for general-purpose pneumatic and fluid-transfer systems using 12 mm OD tubing with M24x1.5 bulkhead panel threads.

Installation Notes

Installation is performed by qualified pneumatic or mechanical technicians. Depressurize and lock out the system before removing or installing any fittings. Ensure the panel hole is sized and threaded to M24x1.5 specification before mounting. Verify tubing is cut square and deburred before insertion into the push-to-connect ends to maintain a leak-free seal.