Norgren 100290800 Bulkhead Connector Push-to-connect

Product Description

The NORGREN 100290800 is a push-to-connect bulkhead tube-to-tube fitting designed to route tubing through a panel, bulkhead, or enclosure wall without additional hardware. Constructed from nickel-plated brass, it delivers corrosion resistance and durability in general-purpose pneumatic and fluid systems. The fitting features an M16x1.5 threaded body for secure panel mounting and accepts 8 mm outside diameter tubing on each end. It is rated for a maximum working pressure of 260 psi and a temperature range of 0 to 175 degrees F. Licensed plumbers, pipefitters, and HVAC-R technicians working with pneumatic control lines or compressed-air distribution typically install this fitting.

This fitting is suited for general-purpose applications in residential and light commercial environments where tubing must pass cleanly through a panel wall or equipment enclosure. Its push-to-connect ends allow fast, tool-free tube insertion on both sides, reducing installation time on control panels, pneumatic actuator assemblies, and compressed-air supply lines. The nitrile O-ring construction provides reliable sealing across a broad service range, making it a practical choice wherever a secure bulkhead tube pass-through is required.

Key Features

• Push-to-connect ends on both sides allow tool-free tube insertion and removal
• Nickel-plated brass body provides corrosion resistance in general-purpose service
• M16x1.5 threaded body for secure panel or bulkhead mounting
• Accepts 8 mm outside diameter tubing on each end
• Nitrile O-rings rated from 0 to 175 degrees F for reliable sealing across typical service conditions
• Rated to 260 psi maximum working pressure

Compatibility

Designed for general-purpose pneumatic and fluid systems using 8 mm outside diameter push-to-connect tubing with an M16x1.5 panel-mount thread.

Installation Notes

Installation is performed by licensed plumbers, pipefitters, or HVAC-R technicians. Depressurize the system completely before removing or installing any push-to-connect fitting. Thread the M16x1.5 body through the panel cutout and secure with the provided locknut, then insert tubing fully into each push-to-connect end until it seats against the internal collet. Verify the tube outside diameter matches the fitting specification before installation to maintain rated pressure performance.