Nordic Pure 19x25x1CustomM10+C-6 Merv 10 Carbon Filter

Product Description

The NORDIC PURE 19x25x1CustomM10+C-6 is a custom-cut, MERV 10 pleated air filter with activated carbon media, sized at a nominal 19x25x1 inches with an actual size of 18.5 x 24.5 x 0.75 inches. Sold in a 6-pack, it is designed for residential and light commercial HVAC systems where both particulate capture and odor reduction are priorities. The electrostatically charged synthetic media captures over 85% of airborne particles in the 3-10 micron range, including dust, pollen, pet dander, mold spores, and lint. The carbon layer addresses common household odors. Licensed HVAC technicians and knowledgeable end-users install this filter as a direct drop-in replacement during routine maintenance cycles.

This filter is suited for forced-air residential heating and cooling systems using a standard 1-inch filter slot. Because this is a custom-made size, the nominal 19x25x1 dimensions are not a standard off-the-shelf footprint. The actual filter measures 18.5 x 24.5 x 0.75 inches. Installers should measure the existing filter opening before ordering. The custom frame is constructed by cutting down or combining standard filter frames, and may use reinforced tape to achieve the specified dimensions. The frame is built with a reinforced 2-part design intended to support structural integrity and consistent airflow over the service life of the filter.

Key Features

• MERV 10 rating captures over 85% of particles in the 3-10 micron range, including pollen, pet dander, lint, dust, and mold spores
• Activated carbon media layer reduces common household and HVAC-system odors
• Electrostatically charged synthetic pleated media for enhanced particle attraction without high airflow restriction
• Reinforced 2-part custom frame built for durability and dimensional stability in the filter rack
• Custom-cut to nominal 19x25x1 inches (actual 18.5 x 24.5 x 0.75 inches) for non-standard filter openings
• Made in the USA

Compatibility

Designed for forced-air residential and light commercial HVAC systems with a filter slot that accepts a nominal 19x25x1 inch filter. This is a custom-made size. Installers should verify the actual opening dimensions before ordering, as this item is non-returnable once manufactured.

Installation Notes

Power down the HVAC system at the thermostat or disconnect before removing the existing filter. Verify airflow direction arrows on the filter frame align with the direction of airflow into the air handler or furnace. Nordic Pure recommends replacing this filter every 30 to 90 days depending on environmental conditions such as pets, occupancy, and outdoor air quality. Because this is a custom size, measure the actual filter slot opening to within 1/8 inch before ordering to ensure proper fit.