Nibco CE00750 45 Degree Elbow 1/2 in Pvdf Sch 80

Product Description

The NIBCO CE00750 is a 45-degree pipe elbow fitting manufactured from PVDF (polyvinylidene fluoride), a high-performance thermoplastic suited for demanding chemical and high-purity fluid handling applications. Built to Schedule 80 wall thickness, this fitting delivers greater pressure capacity and mechanical strength compared to Schedule 40. The 1/2-inch size features Slip x SR FIPT end connections, allowing one socket-style solvent-weld connection paired with a standard reinforced female iron pipe thread on the opposing end. Licensed plumbers and industrial pipefitters are the primary installers of this fitting in both new construction and retrofit piping systems.

This fitting is used in residential and commercial applications where corrosion resistance and chemical compatibility are critical. PVDF is widely specified in chemical processing lines, ultrapure water systems, semiconductor fabrication facilities, and laboratory plumbing. The Schedule 80 rating makes it appropriate for higher-pressure service runs where standard-wall plastic fittings would be insufficient. It installs using standard solvent cement on the slip end and thread sealant on the FIPT connection.

Key Features

• 45-degree elbow geometry for moderate directional changes in piping runs
• PVDF construction provides excellent resistance to many acids, bases, and solvents
• Schedule 80 wall thickness supports higher working pressures than Schedule 40
• Slip x SR FIPT end connections allow solvent-weld and threaded assembly in a single fitting
• 1/2-inch size fits standard half-inch pipe runs

Compatibility

Designed as an OEM-style replacement or new-installation fitting for Schedule 80 PVDF plastic piping systems using 1/2-inch nominal pipe size with Slip and SR FIPT end connections.

Installation Notes

Installation should be performed by a licensed plumber or qualified pipefitter familiar with plastic pipe solvent-welding procedures and threaded connections. Depressurize and drain the piping system fully before cutting into any existing line. Use only PVDF-compatible solvent cement on the slip end and an appropriate thread sealant or PTFE tape on the FIPT connection. Refer to applicable IPC and local plumbing codes for pressure ratings and approved use in potable or chemical service.