National Safety Apparel KITGC0B08 Class 0 Glove Kit Size 8

Product Description

The NATIONAL SAFETY APPAREL KITGC0B08 is a Class 0 rubber lineman glove kit designed for electrical workers who require insulated hand protection during low-voltage tasks. The kit includes a pair of 11-inch black rubber voltage gloves in size 8, along with cowhide leather protector gloves and a storage bag. The rubber gloves are electrically tested and marked with the initial test date, providing a traceable record of compliance. This kit is assembled for use by licensed electricians and utility linemen working on or near energized equipment up to 1,000 volts AC maximum use voltage.

This kit is suited for residential and commercial electrical work where NFPA 70E and CSA Z462 arc flash and electrical safety standards apply. The combination of rubber insulating gloves and leather protectors meets the layered hand-protection approach required in many utility and industrial environments. Size 8 fits both men and women with a corresponding numeric hand size of 8. The 11-inch glove length provides wrist and lower forearm coverage in typical panel, switchgear, and service-entrance work scenarios.

Key Features

• Class 0 rubber insulation rated for up to 1,000 volts AC maximum use voltage
• Electrically tested and marked with the initial test date for compliance traceability
• Includes cowhide leather protector gloves to guard rubber gloves against cuts and abrasion
• Includes a storage bag for proper glove storage between uses
• Meets CSA Z462 and NFPA 70E electrical safety standards
• Available as a complete kit — rubber gloves, leather protectors, and storage bag in one package

Compatibility

Designed as an OEM-style replacement or initial-issue kit for electricians and linemen requiring Class 0 rubber insulating glove protection in compliance with NFPA 70E and CSA Z462 safety programs.

Installation Notes

Rubber insulating gloves must be inspected for cuts, punctures, or degradation before each use; damaged gloves must be removed from service immediately. Installation and use of this PPE kit should follow NFPA 70E or CSA Z462 requirements, which typically mandate energized electrical work permits and appropriate arc flash PPE selection. Always don leather protector gloves over the rubber insulating gloves during use to prevent mechanical damage to the rubber layer. Gloves should be stored away from heat, light, and ozone sources when not in use.