National Mfg N220-228 Galvanized Corner Brace 6x1-1/8 in

Product Description

The NATIONAL MFG/SPECTRUM BRANDS HHI N220-228 is a galvanized corner brace measuring 6 inches by 1-1/8 inches, designed to reinforce and support right-angle joints in a wide range of structural and finish carpentry applications. The hot-dip or zinc galvanized finish resists corrosion, making this brace suitable for use in both interior and moderately exposed exterior settings. Each package contains 10 individual braces, allowing multiple repair or construction tasks to be completed from a single purchase. Carpenters, general contractors, and maintenance technicians commonly install this type of hardware when a durable, low-profile corner reinforcement is required.

This corner brace is suited for light structural and decorative reinforcement tasks across residential and commercial settings. Typical applications include chests, screen frames, window frames, and furniture joints where added rigidity at a 90-degree corner is needed. The bulk pack of 10 units is well suited for service professionals or maintenance crews working on multiple units or completing repeat repairs on similar assemblies.

Key Features

• Galvanized finish provides corrosion resistance for interior and light exterior use
• 6-inch by 1-1/8-inch profile fits standard corner reinforcement applications
• Bulk pack of 10 braces per package reduces per-unit cost on multi-piece jobs
• Flat plate design stays low-profile on finished surfaces
• Suitable for chests, screen frames, window frames, and furniture

Compatibility

Designed as a general-purpose OEM-style corner brace for use in furniture, cabinetry, screen frames, window frames, and chest construction where a 6-inch galvanized flat corner brace is specified.

Installation Notes

Corner braces of this type are typically installed by carpenters, finish tradespeople, or maintenance technicians using standard fasteners appropriate for the substrate material. Power down any associated equipment and secure the workpiece before fastening. Pre-drilling pilot holes is recommended when mounting to hardwood or thin stock to prevent splitting. Follow applicable building or finish carpentry standards for fastener size and spacing.