National Mfg N195-792 Single Swivel Eye Pulley 2 in 480 Lb

Product Description

The NATIONAL MFG/SPECTRUM BRANDS HHI N195-792 is a 2-inch single pulley with a swivel eye mount, designed for lifting, rigging, and load-redirecting applications in trade and industrial settings. The steel body carries a weatherproofed finish to resist corrosion in outdoor or high-moisture environments. Die-cast sheaves and life-lube bearings reduce friction and extend service intervals. The rated safe working load of 480 pounds makes this pulley suitable for moderate-duty overhead and rope-rigging tasks. Licensed contractors, maintenance technicians, and riggers handling cable, rope, or chain runs are the primary installers of this hardware.

This pulley is suited for use in mechanical rooms, equipment yards, outdoor rigging setups, and anywhere a single-sheave swivel block is needed to change the direction of a rope or cable run. The swivel eye allows the pulley to rotate and self-align with the load direction, reducing side-loading on the mount point. It is commonly used in HVAC equipment rigging, general construction, and maintenance applications where a compact, corrosion-resistant block is required. Each package contains 5 units.

Key Features

• 2-inch single sheave for use with rope or cable
• Swivel eye mount allows load self-alignment and reduces side-load stress
• 480-pound safe working load rating
• Steel body with weatherproofed finish for corrosion resistance in outdoor use
• Die-cast sheaves for smooth, low-friction rope travel
• Life-lube bearings reduce maintenance requirements

Compatibility

Designed as a general-purpose single swivel eye block suitable for standard rope and cable rigging applications where a 2-inch sheave and 480-pound working load rating meet the installation requirements.

Installation Notes

Installation should be performed by a qualified rigger or licensed contractor familiar with applicable load-rating and overhead rigging standards. Always verify that the anchor point and fasteners are rated at or above the intended working load before use. Inspect the swivel eye, sheave, and bearing for damage or wear before each use. Never exceed the rated safe working load of 480 pounds.