National Mfg N193-714 Zinc Flex Door Hanger Offset Bolt 2PK

Product Description

The NATIONAL MFG/SPECTRUM BRANDS HHI N193-714 is a 2-pack of zinc flexible sliding door hangers with an offset bolt, designed for round-track sliding door systems. Each hanger features a 0.5-inch offset, 9-inch bolt that allows vertical and lateral door adjustment from inside the building without removing the door from the track. The flexible hanger design absorbs stress to resist door panel damage during operation. Wheels provide quiet, smooth rolling performance. This hardware is packaged and sold as a set of two and is suited for residential and light commercial barn-style or sliding door installations.

These hangers are intended for use on round-track sliding door systems. The offset bolt adjustment makes them well-suited for applications where fine-tuning door alignment after installation is necessary, including retrofits and new installations where plumb or level tolerances require on-site correction. Installation is performed from inside the building, reducing the need for exterior access during setup or adjustment. Compatible replacement hangers are commonly installed by carpenters, finish contractors, and general handymen following manufacturer hardware guidelines.

Key Features

• Zinc construction for corrosion resistance in interior applications
• 0.5-inch offset, 9-inch bolt enables vertical and lateral door adjustment from inside the building
• Flexible hanger design resists door panel damage caused by track misalignment or impact
• Quiet and smooth-rolling wheels reduce noise and friction during door operation
• Sold as a 2-pack for complete single-door hanger replacement
• Designed for round-track sliding door systems

Compatibility

Designed for use on round track sliding door systems. Compatible with track models 190-726, 190-727, 190-729, 157-196, 157195, and 157-197.

Installation Notes

Installation is typically performed by a carpenter or general contractor following the door hardware manufacturer guidelines. Disengage or secure the door panel before removing existing hangers to prevent the door from falling. Use appropriate fasteners rated for the door panel weight and track system load. Verify bolt adjustment for both vertical and lateral alignment before securing the door panel in its final position.