National Mfg N186-858 Aluminum Pocket Door Hardware Kit

Product Description

The NATIONAL MFG/SPECTRUM BRANDS HHI N186-858 is a pre-assembled aluminum rail pocket door hardware kit designed for interior pocket door installations. The one-piece header system supports doors from 24 to 36 inches wide and up to 80 inches tall, accommodating door thickness from 0.75 inches to 1.75 inches and a maximum door weight of 125 pounds. Each complete set arrives ready to install, reducing staging time on the job. This hardware is suited for new-construction rough-in and remodel work where a sliding pocket door is required in place of a swing door.

This kit is intended for single pocket door applications in residential framing projects. It works with doors 24 to 36 inches wide and up to 80 inches high, making it compatible with standard interior door openings. The pre-assembled one-piece header simplifies layout and framing. Carpenters, finish trim contractors, and experienced DIYers typically install this system during the rough-in phase before drywall is applied.

Key Features

• Pre-assembled one-piece header system reduces on-site assembly time
• Supports doors up to 125 pounds per panel
• Accommodates door thickness from 0.75 inches to 1.75 inches
• Compatible with door widths from 24 to 36 inches and heights up to 80 inches
• Includes steel studs, header assembly, door guides, 4 wheel hangers, door bumper, door brackets, hanger locks, rail brackets, top stud brackets, floor stud brackets, and screws
• Aluminum rail construction for corrosion resistance in interior environments

Compatibility

Designed as an OEM-style replacement or new-installation hardware set for standard interior pocket doors ranging from 24 to 36 inches wide and up to 80 inches tall with thickness between 0.75 inches and 1.75 inches.

Installation Notes

Install during rough-in framing before drywall is applied. Ensure wall cavity depth is sufficient to receive the full door panel when open. Follow local building codes for interior non-load-bearing partition framing. A licensed carpenter or qualified framing contractor should verify header load requirements before installation.