Mueller Streamline PDWV4861-LH-3X3X2 Pvc Dwv Elbow

Product Description

The MUELLER STREAMLINE PDWV4861-LH-3X3X2 is a 90-degree PVC DWV elbow with a low heel inlet, sized at 3 inches x 3 inches x 2 inches. This fitting is designed for drain, waste, and vent (DWV) piping systems where a branch connection must enter at the low heel of the elbow. All three hubs accept solvent-weld connections, providing a secure, leak-resistant joint. Plumbers and pipefitters install this type of fitting during rough-in work on residential and light commercial drain systems. The PVC construction resists corrosion and common household drain chemicals.

This elbow is used in PVC DWV systems where a 90-degree change of direction is needed along with a simultaneous branch takeoff at the low heel position. The 2-inch low heel inlet allows a secondary drain line to tie into the main 3-inch run at the elbow. Typical applications include bathroom drain rough-ins, laundry standpipe connections, and other gravity-flow drain configurations where code requires a low heel inlet rather than a side inlet arrangement.

Key Features

• 90-degree sweep provides a compliant change of direction in gravity-flow DWV systems
• Low heel inlet configuration allows a 2-inch branch connection at the base of the elbow
• Hub x Hub x Hub (H x H x H) ends accept standard solvent-cement joints
• PVC material resists corrosion, scale buildup, and common drain effluents
• Sized for 3-inch main run with a 2-inch branch — a common residential drain rough-in combination

Compatibility

Designed as an OEM-style replacement or new-installation fitting for residential and light commercial PVC DWV piping systems using 3-inch and 2-inch schedule pipe with solvent-weld hub connections.

Installation Notes

Installation is performed by a licensed plumber in accordance with the applicable plumbing code, such as the IPC or UPC. Shut off water supply and confirm the drain line is clear before cutting into an existing system. Clean and prime all hub surfaces before applying solvent cement, and allow full cure time before restoring flow. Do not apply heat to PVC fittings and do not use petroleum-based lubricants with PVC solvent-weld joints.

Technical Specifications

• Material: PVC
• Fitting Type: 90 Degree DWV Elbow with Low Heel Inlet
• Main Run Size: 3 inches x 3 inches
• Branch Inlet Size: 2 inches
• End Type: Hub x Hub x Hub (Solvent Weld)
• Application: Drain, Waste, and Vent (DWV)

Standard Information

• Brand: MUELLER STREAMLINE
• Manufacturer Part Number: PDWV4861-LH-3X3X2