Mueller Streamline LS-1183835-08EZ Ez Pull Line Set

Product Description

The MUELLER STREAMLINE LS-1183835-08EZ is a factory-insulated copper refrigeration line set built for HVAC installations that demand clean, fast routing. The EZ Pull outer jacket reduces friction against framing, studs, and tight conduit runs, allowing the line set to be pulled through walls and ceilings with less effort and less risk of jacket damage. The suction line measures 1-1/8 inches OD and the liquid line measures 3/8 inches OD, with 1/2-inch wall insulation covering the suction line. Total run length is 30 feet. Licensed HVAC technicians and refrigeration mechanics are the primary installers of this product.

This line set is suited for higher-capacity residential split systems and light commercial applications where a 1-1/8-inch by 3/8-inch line pair is specified. The 30-foot length covers typical wall-to-rooftop or wall-to-ground-level condenser runs in single-family homes and small commercial buildings. The pre-insulated construction eliminates field-applied insulation labor on the suction line, saving time on new installations and changeouts alike. The EZ Pull jacket design is especially useful when routing through finished walls or through multiple top plates.

Key Features

• EZ Pull outer jacket reduces friction during installation through framing and tight pathways
• 1-1/8-inch OD suction line and 3/8-inch OD liquid line sized for higher-capacity systems
• 1/2-inch insulation wall on suction line factory-applied for consistent thermal performance
• 30-foot length suits most standard residential and light commercial line runs
• Copper construction provides reliable refrigerant-grade pressure and corrosion resistance

Compatibility

Designed as an OEM-style replacement or new-installation line set for residential and light commercial split-system HVAC equipment requiring a 1-1/8-inch by 3/8-inch copper line pair on a 30-foot run.

Installation Notes

Installation should be performed by a licensed HVAC or refrigeration technician following applicable mechanical codes and EPA Section 608 refrigerant handling requirements. Isolate and recover refrigerant from any existing system before disconnecting old line sets. Protect cut line ends from debris and moisture during routing, and braze or flare connections per the equipment manufacturer's joining specifications. Avoid kinking the lines during the pull, and support the line set at intervals appropriate to local code requirements.

Technical Specifications

• Suction Line OD: 1-1/8 inches
• Liquid Line OD: 3/8 inches
• Insulation Thickness: 1/2 inch
• Line Set Length: 30 feet
• Material: Copper
• Jacket Type: EZ Pull

Standard Information

• Brand: MUELLER STREAMLINE
• Manufacturer Part Number: LS-1183835-08EZ