Mueller Industries KS05060 Seamless Copper Tube 60 Ft

Product Description

The MUELLER INDUSTRIES KS05060 is a seamless copper tube used in plumbing, HVAC refrigerant lines, and mechanical piping systems. It measures 60 feet in length with a 3/4-inch outside diameter, a 5/8-inch nominal size, and a 0.049-inch wall thickness. The seamless construction eliminates longitudinal weld seams, which reduces the risk of leaks at high-pressure or high-cycle applications. At 0.418 pounds per foot, the total coil weight is approximately 25.08 pounds. Licensed plumbers, HVAC technicians, and mechanical contractors are the primary installers of this product.

This copper tube is suited for residential and light commercial applications including domestic water supply, drain-waste-vent rough-in, hydronic heating loops, and refrigerant suction or liquid lines where 3/4-inch OD copper is specified. The 60-foot length reduces the number of field joints needed in longer runs, making it practical for new construction and retrofit work alike. Its inside diameter of 0.625 inches supports consistent flow characteristics across the run.

Key Features

• Seamless copper construction — no longitudinal weld seam for improved pressure integrity
• 3/4-inch outside diameter with 0.625-inch inside diameter and 0.049-inch wall thickness
• 60-foot continuous length reduces the number of field joints in long runs
• 0.418 pounds per foot linear weight for straightforward load and hanger calculations
• Compatible with standard solder, braze, and compression fittings designed for 3/4-inch OD copper tube

Compatibility

Designed for use with standard fittings and valves dimensioned for 3/4-inch OD seamless copper tube in plumbing and HVAC refrigerant or hydronic applications.

Installation Notes

Installation should be performed by a licensed plumber or HVAC technician in accordance with the applicable edition of the IPC, IMC, or local mechanical code. Isolate and depressurize the system and, where applicable, recover any refrigerant before cutting into an existing line. Use a sharp tube cutter to achieve a clean square cut, and ream the cut end before fitting to remove burrs that can restrict flow. Support spacing should follow code-required intervals for copper tube of this diameter and wall thickness.