Mueller Industries BDNA-15815 Wrot Copper 90 Elbow 1/8 C X C

Product Description

The MUELLER INDUSTRIES BDNA-15815 is a wrot copper 90 degree elbow fitting sized at 1/8 inch by 1/8 inch with copper-to-copper sweat connections on both ends. Wrot copper fittings are manufactured from wrought copper, giving them a denser, more uniform grain structure than cast fittings. This elbow is used to redirect copper tubing runs at a 90 degree angle in tight or confined spaces. The outside diameter measures 1/4 inch on each end. Licensed plumbers and HVAC technicians install this fitting using standard soldering practices in water supply, refrigeration, and gas distribution systems where 1/8 inch tubing is specified.

This fitting is suited for residential and light commercial plumbing and HVAC applications where small-diameter copper tubing changes direction. Typical install scenarios include instrument lines, pilot gas lines, refrigeration sensing lines, and small-bore water supply connections. The C x C (sweat) end connection type requires flux and solder for a permanent, pressure-rated joint. This SKU is sold individually and carries a minimum order quantity of 10 units, making it appropriate for stocking in service vehicles or shop inventory.

Key Features

• Wrot copper construction for dense grain structure and consistent wall thickness
• 90 degree elbow geometry for direction changes in small-diameter tubing runs
• C x C sweat connections on both ends for standard soldered joints
• 1/8 inch by 1/8 inch fitting size with 1/4 inch outside diameter on each end
• Lightweight at 0.01 pounds per piece, suitable for tight spaces and instrument lines

Compatibility

Designed as an OEM-style replacement and new-installation fitting for 1/8 inch copper tubing systems using sweat-type connections in plumbing, HVAC, and refrigeration applications.

Installation Notes

Installation is performed by a licensed plumber or HVAC technician following applicable IPC and IFGC code requirements. Shut off and depressurize the system and purge any remaining fluid before cutting into an existing line. Clean tubing ends and fitting cups thoroughly, apply lead-free flux, and solder with an appropriate torch per local code requirements. Do not overheat small-diameter wrot copper fittings, as excess heat can damage nearby components or weaken the joint.