Mueller Industries 3413 Abs Dwv Cleanout Tee 1-1/2 in

Product Description

The MUELLER INDUSTRIES 3413 is a 1-1/2 inch ABS DWV cleanout tee designed for drainage, waste, and vent piping systems in residential and light commercial construction. This solvent-weld fitting is manufactured from ABS thermoplastic, a non-corrosive material well suited for indoor DWV applications. The cleanout tee provides a dedicated female access port for rodding, snaking, or camera inspection without requiring pipe removal. All three ports are sized at 1-1/2 inches. Licensed plumbers install this fitting during rough-in or as part of an accessible cleanout installation in retrofit work.

This fitting is used in gravity-flow DWV systems where code-compliant cleanout access is required. It is appropriate for new construction rough-in and retrofit applications in residential and light commercial buildings. The female cleanout outlet accepts a standard threaded cleanout plug, keeping the access point closed during normal operation while remaining easy to open for service. It is not rated for pressurized supply lines.

Key Features

• ABS thermoplastic construction resists corrosion and chemical attack common in drain waste environments
• Solvent-weld (plastic x plastic) connections on the run ends for a permanent, leak-resistant joint
• Female threaded cleanout outlet allows easy plug installation and removal for drain service
• Uniform 1-1/2 inch sizing on all three ports simplifies integration into standard DWV runs
• Suitable for both new construction rough-in and retrofit cleanout installations

Compatibility

Designed as an OEM-style solvent-weld replacement or new-installation fitting for 1-1/2 inch ABS DWV drain, waste, and vent piping systems.

Installation Notes

Installation is performed by a licensed plumber in accordance with the International Plumbing Code or applicable local code requirements for cleanout placement and accessibility. All solvent-weld joints must be made with ABS-rated primer and cement following the fitting manufacturer and cement manufacturer instructions. Ensure the drain system is depressurized and dry before cutting into an existing line. Do not use this fitting on pressurized water supply lines.