Mitee-bite 90115 Irregular Hex Clamp 1-6mm Hex 1/2-13

Product Description

The MITEE-BITE 90115 is an irregular hex clamp designed for precision workholding in machining and fixture applications. It uses a 1/2-13 stud thread and accepts hex sizes ranging from 1 to 6mm, making it adaptable across a range of workpiece geometries. The serrated edge surface increases grip and resists slippage under load. At a rated torque of 65 ft/lb and a holding force of 4,000 pounds, this clamp is built for production environments where consistent clamping pressure and repeatability are critical. The hex height measures 0.394 inches, keeping the clamp profile low for clearance-sensitive setups. Machinists, toolmakers, and fixture builders are the primary users of this component.

The MITEE-BITE 90115 is suited for use on CNC machining centers, milling fixtures, and custom workholding setups where standard clamps cannot engage a flat or regular surface. The 1 to 6mm hex size range allows it to engage irregularly shaped workpieces or hex-featured parts directly. A thread length of 1 inch provides sufficient engagement depth for solid stud retention. This clamp is commonly used in low-profile fixture plates and tombstone-style setups where vertical clearance is limited and side-access clamping is preferred.

Key Features

• Accepts 1 to 6mm hex sizes for use on irregular or hex-featured workpieces
• Serrated edge surface provides enhanced grip and slip resistance under cutting forces
• 4,000 lb holding force rated for production-level clamping demands
• 65 ft/lb torque rating ensures consistent, repeatable clamping pressure
• Low-profile hex height of 0.394 inches suits clearance-restricted fixture layouts
• 1/2-13 stud thread is a common standard size compatible with widely available fixture hardware

Compatibility

Designed as an OEM-style workholding component for use with 1/2-13 threaded fixture studs in milling and machining setups requiring irregular hex clamping.

Installation Notes

Installation is performed by machinists or toolmakers setting up workholding fixtures on CNC or manual milling machines. Ensure the fixture plate stud is properly torqued into the table or base before seating the clamp. Apply torque to the clamp gradually and evenly to the specified 65 ft/lb value using a calibrated torque wrench. Power down and lock out the machine spindle before adjusting or removing any clamp during a setup change.