Milwaukee Tool 48-73-8652E Cut Resistant Gloves A5

Product Description

The MILWAUKEE TOOL 48-73-8652E is an ANSI/ISEA A5 cut-resistant and puncture-resistant work glove designed for trade professionals who handle sharp materials, sheet metal, conduit, pipe, and abrasive surfaces. The glove features a synthetic leather shell with a nitrile dip coating across the palm and fingers, providing a secure grip in both dry and lightly oily conditions. The ANSI/ISEA abrasion resistance rating of 5 reflects a shell that holds up under repeated contact with rough surfaces. At 9 inches in overall length, the glove covers the hand and a portion of the wrist. Sold as a pair in a large unisex size, this glove suits HVAC, mechanical, plumbing, and electrical work where hand protection against cuts and punctures is required.

The 48-73-8652E is suited for residential and commercial trade applications where workers regularly encounter sharp edges, wire ends, sheet metal burrs, or rough pipe. The elastic cuff in red keeps the glove snug at the wrist during overhead work or in tight spaces. The nitrile-dipped grip surface improves control on tools, fittings, and conduit without sacrificing dexterity. HVAC technicians, pipefitters, electricians, and general mechanical contractors will find this glove appropriate for day-to-day material handling and installation tasks.

Key Features

• ANSI/ISEA Cut Resistance Level A5 for protection against sharp sheet metal, wire, and edged materials
• ANSI/ISEA Puncture Resistance Level 5 for protection against wire ends, staples, and sharp fasteners
• ANSI/ISEA Abrasion Resistance Level 5 synthetic leather shell withstands repeated contact with rough surfaces
• Nitrile dip coating across palm and fingers provides grip in dry and lightly oily conditions
• Elastic cuff keeps the glove securely positioned during active work
• Sold as a pair in large unisex sizing

Compatibility

Designed as a general-purpose cut and puncture resistant work glove for trade professionals. Suitable for HVAC, plumbing, electrical, and mechanical applications where ANSI/ISEA A5 cut resistance is specified by a safety program or job-site requirement.

Installation Notes

Inspect gloves before each use for cuts, tears, or coating separation that may reduce protection. Replace immediately if the nitrile coating is cracked or the shell is compromised. Gloves should be selected and worn in accordance with the applicable job-site PPE program and OSHA hand protection requirements under 29 CFR 1910.138. Do not use these gloves as a substitute for arc-flash or electrical-insulation rated hand protection.