Milwaukee Tool 48-73-8650E Cut Resistant Gloves A5

Product Description

The MILWAUKEE TOOL 48-73-8650E is a cut and puncture resistant work glove rated ANSI/ISEA Cut Level A5 and Puncture Level 5, built for trade professionals who handle sharp materials, sheet metal, conduit, pipe, or glass. The glove features a nitrile-dipped palm and finger coating over a synthetic leather shell, providing grip and abrasion resistance in wet or dry conditions. The elastic cuff delivers a secure fit during active use. At 7 inches in overall length, the glove covers the hand and wrist junction without restricting wrist movement. Licensed HVAC techs, plumbers, electricians, and sheet metal workers regularly specify A5-rated gloves for handling cut stock, ductwork edges, and copper pipe.

This glove is designed for general trade and industrial work environments where laceration and puncture hazards are present. The nitrile coating on the palm and fingers improves grip on smooth metal surfaces, fittings, and tools. The synthetic leather construction on the back and lining adds durability without adding bulk. Sized for small hands, the unisex fit works across a range of hand profiles. The pair format means both hands are covered. This glove is not FDA approved and does not provide a blood-borne pathogen barrier, so it is not suitable for medical or biohazard applications.

Key Features

• ANSI/ISEA Cut Resistance Level A5 for protection against sharp metal edges and glass
• ANSI/ISEA Puncture Resistance Level 5 for nail, wire, and spike hazards
• ANSI/ISEA Abrasion Resistance Level 5 for extended durability on rough surfaces
• Nitrile-dipped palm and finger coating for grip in wet and dry conditions
• Synthetic leather shell and lining with elastic cuff for a secure, low-bulk fit
• Overall length of 7 inches covering the palm through the wrist

Compatibility

Designed as a general-purpose cut and puncture resistant work glove for trade professionals in HVAC, plumbing, electrical, and sheet metal applications where ANSI/ISEA A5 cut protection is required.

Installation Notes

Inspect gloves before each use for tears, punctures, or coating separation that would reduce protection. Gloves should be worn when cutting, handling, or installing materials with sharp edges such as sheet metal duct, conduit, copper pipe, or wire. Replace gloves when the coating shows significant wear or when the shell is compromised. These gloves do not substitute for arc flash, chemical, or electrical insulation PPE where those hazards are present.