Milwaukee Tool 48-73-7010 Cut A7 Gloves Small

Product Description

The MILWAUKEE TOOL 48-73-7010 is an 18-gauge cut and puncture resistant work glove rated ANSI/ISEA Cut Level A7 and ANSI/ISEA Puncture Resistance Level 3. Built from a high-performance polyethylene, tungsten steel, and nylon blend shell, the glove features a nitrile dipped palm and fingertip coating for grip and durability. The seamless HPPE lining delivers total hand coverage without seam pressure points, while a knit cuff and nylon-spandex back provide a close, breathable fit. Licensed electricians, plumbers, HVAC techs, and general trade workers use this glove for tasks that demand both dexterity and protection when handling sharp components, sheet metal, copper tubing, or conduit.

Sized for men's small or women's x-small, the 48-73-7010 suits light-to-medium trade work where fine motor control matters. The high dexterity design supports handling small parts, fittings, and fasteners without removing the glove. Smartswipe touchscreen-compatible fingertips allow device use on the job. A reinforced nitrile coating between the thumb and index finger addresses the high-wear zone most common in gripping and pulling tasks. The EN 388 rating of 4X43F confirms independent lab performance across abrasion, cut, tear, and puncture categories.

Key Features

• ANSI/ISEA Cut Level A7 with EN 388 rating 4X43F for verified cut protection
• ANSI/ISEA Puncture Resistance Level 3 — nitrile dipped palm and fingertips
• 18-gauge HPPE, tungsten steel, and nylon blend shell for strength without bulk
• Seamless lining for all-day comfort during repetitive hand tasks
• Reinforced nitrile coating at thumb-index finger zone for extended wear life
• Smartswipe touchscreen-compatible fingertips — no need to remove glove for device use

Compatibility

Designed as a general-purpose cut and puncture resistant work glove for trade professionals. Fits men's small or women's x-small hand sizes. Part of the Milwaukee Tool 48-73 Series of work gloves.

Installation Notes

Inspect gloves before each use for coating separation, tears, or worn-through areas that would reduce protection. Do not use these gloves as a substitute for arc-rated or voltage-insulating PPE in live electrical work. Follow applicable OSHA hand protection requirements and your employer's PPE program when selecting gloves for specific hazard levels.