Milwaukee Tool 48-32-4671 Square Power Screwdriver Bit 5 Pack

Product Description

The MILWAUKEE TOOL 48-32-4671 is a square-tip power screwdriver bit designed for use with impact drivers and power screwdrivers in demanding trade applications. Built from alloy steel, this bit measures 2 inches in overall length and accepts a 1/4 inch hex shank for quick-change tool compatibility. Rated as an impact-ready bit, it is engineered to handle the rotational stress and shock loads generated by pneumatic and electric impact drivers. Sold in a 5-pack, it suits high-volume fastening work where bit wear and replacement are routine concerns for electricians, HVAC technicians, plumbers, and general contractors.

This bit is suited for residential and light commercial construction and service work where square-drive fasteners are common. Square-drive screws are widely used in decking, electrical panel work, and HVAC cabinet assembly. The 1/4 inch hex drive shank fits the quick-release chucks found on most cordless and corded power screwdrivers and impact drivers, making this bit a practical addition to any trade tool kit. The 5-pack format supports job-site continuity by keeping spares on hand.

Key Features

• Square drive tip compatible with standard square-drive fasteners used across multiple trades
• 1/4 inch hex shank fits quick-change chucks on cordless and corded impact drivers
• 2 inch overall length provides clearance for recessed fastener locations
• Alloy steel construction rated for impact-ready use under high torque and shock loads
• 5-pack quantity reduces downtime from bit wear on high-volume fastening tasks

Compatibility

Designed as an impact-ready replacement screwdriver bit for use with any power screwdriver or impact driver equipped with a standard 1/4 inch hex quick-change chuck.

Installation Notes

Installation is performed by trade professionals including electricians, HVAC technicians, and plumbers using standard 1/4 inch hex chuck impact drivers or power screwdrivers. Ensure the bit is fully seated in the tool chuck before applying power to prevent cam-out or bit ejection. Inspect bits for wear or deformation before each use and replace when drive tip shows visible rounding. No special tools or code compliance steps are required for bit replacement itself, but always follow applicable safety standards when operating power tools on energized or pressurized systems.